Coating Eraser is a super concentrated, heavy-duty formulation used to penetrate and emulsify dirt, grease, oil, paint, and stain. Coating Eraser is for use on wood and concrete surfaces. It can also clean asphalt and fiber glass shingles. Coating Eraser will work in cold water as well as hot water, and rinse free at any temperature.

DIRECTIONS FOR USE:

Apply Coating Eraser either pure or ip to 1:3 depending on the thickness of the finish needing to be removed. Scrape and/or utilize a high pressure rinse.

Must be diluted before use, 1 gallon makes 5 gallons. The optimum cleaning dilution for most surfaces is between 1:2 and 1:4. When stripping paint, stains, and sealers use at full strength. Thoroughly wet the entire area to be cleaned. Broom out any puddles of water. Spray solution on with a low pressure applicator, let stand to penetrate for ten minutes. Stubborn areas of layered paint may require brushing and reapplication of Coating Eraser. Rinse with low pressure to avoid damage to wood, high pressure rinse on concrete.

For cleaning Asphalt Shingles: Coating Eraser is a Super Concentrate and is meant to be diluted before being used for roof cleaning. 1 gallon will make 4.

Note Furter Dilution:

To Apply To Asphalt Shingles: further dilute 1:10. When cleaning with a pressure washer and if on a vertical surface, always apply cleaning solutions from the bottom up and always rinse from the top down.

Do not use on polished or anodized aluminum. Do not use on any aluminum or painted surfaces at use of concentration of 1:40. Do not allow to dry on surfaces. Always rinse thoroughly.